ElliboHelp Centre

Documents and revisions

Drawings, specifications, CAD files and manuals with revision letters, released by hand or with a change order.

Documents with revisions come with Standard and up. Open Documents: Current shows each document's draft and released revisions; Replaced shows older ones.

Add a document

  1. Click New document, or + New document on a product.
  2. Give it a Title, its Kind (drawing, specification, CAD file, manual or instructions, test report, other) and its Product.
  3. Click Make the document. It gets a number such as DOC-00001 and starts at revision A (or 1) as a draft.
  4. Under File, click + Add the file: PDF, pictures, DXF, DWG, STEP, IGES, STL, office files or a ZIP, up to 50 MB.

Release a revision

An engineering manager clicks Release. The revision is now Released, and any earlier released revision of the same document becomes Replaced. A released revision and its file can't change.

A new revision

On a released document, click New revision: a draft with the next letter is made from it. Change the file, then release it.

With a change order

A document can belong to a change order (Released with change). On a change order, + New adds a document, and Revise with this change starts the next revision of one of the product's released documents. These drafts are released when the change is applied, so drawings always match the product.

Every revision of a document is listed under Revisions on its page.

Still need help?Write to us and we'll walk you through it.
Contact support